Reverse Hack Squat
Why it matters
The Reverse Hack Squat builds strength and size in your quadriceps, glutes, hamstrings and rectus abdominis. As a compound movement, it trains several muscles together and carries over to real-world strength and power.
How to do it
- Adjust the seat and any pads so the working joint lines up with the machine’s pivot, set the pin to your working weight, and keep contact with the support pad throughout.
- Set your feet about shoulder-width with your toes turned out slightly.
- Take a full breath into your belly and brace before you descend.
- Break at the hips and knees together and lower under control.
- Descend until your thighs reach at least parallel to the floor.
- Drive through the middle of your foot to stand back up.
Coaching cues
- Think about pulling your shoulder blades apart at the top rather than yanking with your arms.
- Keep the load stacked over the middle of your foot.
- Let your knees track in line with your toes.
- Push your knees out as you descend into the bottom.
- Drive through your knees and feel the front of your thighs work.
Watch out for
-
Letting the knees cave inward under load.
Caved knees are a weaker position and rob power from the lift.
Instead Push your knees out toward your little toes as you descend and stand.
-
Rising hips-first so the load shifts forward onto your toes.
Hips shooting up first tips you forward and turns the squat into a good morning.
Instead Lead with your chest and drive your hips and shoulders up at the same rate.
-
Cutting the depth short above parallel.
A shallow squat trains a fraction of the range and much less of your legs.
Instead Lower until your hip crease drops below the top of your knee.
-
Letting the weight stack slam down at the bottom.
A slammed stack means gravity did the lowering, not your muscles.
Instead Control the return so the plates settle without banging.
The detail
- Tempo
- Lower under control for about two counts, then stand with intent.
- Breathing
- Take a big breath at the top, hold it through the descent and drive, then exhale at the top.
- Range of motion
- Aim for thighs at or below parallel while keeping your heels flat on the floor. Take the quadriceps through its full working range each rep.
- Setting up
- Adjust the seat and any pads so the working joint lines up with the machine’s pivot, set the pin to your working weight, and keep contact with the support pad throughout.
- If you are new to it
- Start with a box or bench behind you to learn consistent depth.
- Once it is easy
- Add a pause in the bottom position to build strength out of the hole.